Quick Start Guide Version 1.1
Atop ABLELink
®
Wireless Serial Server
SW2001／SW5001
2
LED Indications: The LEDs were indicated for SW2001/5001’s status
Name Color Status Description
Red(1) ON
Its strength is poor, but the link is connected for the wireless
link
Yellow(2) ON
Its strength is fair or good, the wireless link can supply a
good transfer channel
Signal
Strength
Green(2) ON
Its strength is very good and the link is connected on best
status
Off
Wireless Link is Broken or No data transmit or receive via
wireless connectivity
WLAN Red
Blink Wireless Traffic be indicted for data transfer
Off No data transmit or receive via serial port
COM Red
Blink
Serial traffic be indicted for data transfer
OFF/ON System is not ready or halt
RUN Red
Blink System is running and LED is blink per 0.5 sec
Hardware installing procedure for initialization
Step 1: Pick the device up from the packaged box, connected Ethernet-link to LAN switch with
standard UTP cable.
Step 2: Attached the power wire to the device for 9~24V DC, and confirm the power polarity
carefully.
Step 3: Wait the device start up after 10~20 Seconds, and See the next section for software
installing
UL Notice for Power supplier
All the series of EH products are intended to be supplied by a Listed Power Unit marked with
“LPS”, “Limited Power Source” or “Class 2” and output rate 9~30VDC, 0.5A minimum. Or, use
the recommended power supply in “Optional Accessories.
3.Software Installing
Configure by monitor.exe utility
Use monitor.exe that comes with product CD or diskette to configure the network parameters of
SW2001/SW5001. Please refer to Appendix D Configuration Utility in the product user manual for
more details.
Step 1: Find new device and IP assignment
Step 2: User Monitor.exe for new device, get device’s current IP from table list
Step 3: Re-assigned IP, network mask and gateway if need with Monitor.exe.
Step 4: Configurative wireless, serial and connectivity mode by web browser or telnet tool.
Auto IP with DHCP
A DHCP server automatically assigns the IP address and network settings. SW2001/5001 supports
DHCP. It will supply for the unit with an IP address gateway address, and subnet mask. You may use
Monitor.exe software to search network information automatically by putting a check on Auto IP on
Dialog window.
Configure by web server
Step 1:Open web browser, type in the IP address of SW2001/SW5001 to be configured. Default
user name is admin and default password is null.
Step 2:Configure settings from web page links then click “Save Configuration” to save settings.
Step 3:Click on ”Restart” button to make the change effective
.
(46 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales